GE Monogram ZIBI240HII Manual de Instalação

Design Guide with InstallationInstructionsFresh-Food RefrigeratorZIFI240ZIFS240Bar Refrigerator with IcemakerZIBI240ZIBS240monogram.com

10Installation Instructions• Remove top plug/bushing from the door using a flat head screwdriver. Discard the bushing.• Rotate the door 180°. • Remove

STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE (ZIFI240 and ZIBI240 models only)3/4” Overlay Panel DimensionsModel ZIFI240 and ZIBI240 require a

12STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE (CONT.) (ZIFI240 and ZIBI240 models only)Installation Instructions• Slide overlay panel into th

STEP 7 SLIDE PRODUCT INTO THE CUTOUTCAUTION Do not push against the door panel with your knees. Do not push or lift the unit by the door handle. Da

14Notes

15Notes

Pub. No. 31-51544-8Part No. 197D5893P00201-15 GEPrinted in SloveniaNOTE: While performing installations described in this book, safety glasses or gog

2Safety InformationBEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT – Save these instructions for local inspector’s use.

3AVERTISSEMENT Risque d’explosion. Conservez les matériaux et vapeurs inflammables tels que l’essence à l’écart de votre réfrigérateur. Le non-res

4CARING FOR YOUR STAINLESS STEEL• Before installation or first use, we strongly advise that you polish the stainless steel exterior and handle with

THE INSTALLATION SPACE THE INSTALLATION SPACE (cont.) * For a standard installation: The product must be installed so that the stainless steel front

PRODUCT CLEARANCESThe Fresh-Food Refrigerator or Bar Refrigerator with Icemaker is factory set for a 110° door swing.When installed in a corner:• Allo

NOTE: If installing between frameless cabinets, a 1/2” wide filler strip or side panel may be needed on the hinge side. The filler strip will act as a

8STEP 1 REMOVE PACKAGING AND INSTALLATION PARTS• Remove corner blocks and foam drawer stops.• Remove all packing material, tape and protective pla

9Installation Instructions• Install the new left bottom hinge pin and new door stop that are enclosed in the hardware bag.• Install the bottom trim on