GE Monogram ZICP360NXRH Manual de Instalação

Design Guide withInstallationInstructions36″ Built-In Bottom-Freezer Refrigeratorsmonogram.com

STEP 1 REMOVE PACKAGINGCAUTION: Refrigerator is much heavier at thetop than at the bottom—be careful when moving. Whenusing a hand truck, handle from

BlockSoffitSide ViewHeightFromFloorto Bottomof WoodBlockBracketsRequiredBracketsNot RequiredBeneath a Soffit11STEP 2A WATER LINE INSTALLATION WITHA R

12STEP 5 LEVEL REFRIGERATORAll models have 4-point leveling. The front is supportedby leveling legs, the rear is supported by adjustablewheels. Both

STEP 8 ADJUST DOOR SWINGNOTE: This refrigerator has a 2-position door stop.When space does not allow the door to swing openfully to 130°, you may cha

14STEP 10 INSTALL 1/4″ FRAMED PANELS• There are two sets of holes in the handle side trim.Replace handle side trim by installing the original screwsi

15STEP 10A INSTALL OVERLAY PANELS• There are two sets of holes in the handle side trim.Replace handle side trim by installing the original screwsin t

16STEP 11 CONNECT WATER SUPPLY• Locate and bring tubing to the front of the cabinet.• Turn the water on to flush debris from line. Run abouta quart o

17Installation InstructionsSTEP 14 INSTALL TOEKICK• Locate the supplied toekick (shipped taped to the side of the refrigerator). Install with 2 screw

18Notes

19Notes

Safety InformationSkill Level— Installation of this refrigerator requiresbasic mechanical, carpentry and plumbing skills.Proper installation is the re

NOTE: While performing installations described in this book,safety glasses or goggles should be worn.For Monogram®local service in your area, call 1.8

36" Frame to Frame Width*84" FromFloor toTop Frame35"Case Width*83-1/2" atRear25-3/8" Framed Models25-3/4" Stainless Ste

1/4"1/2"3/4"1"1-1/4"1"3/4" OverlayPanel(Nominal Size)Stainless Steel1/4"1/2"3/4"2"1-1/4"1-

1/4"1/2"3/4"1"1-1/4"1/4"1/2"3/4"1"1-1/4"1-1/2"23-7/8"From Rear of Refrigerator3/4" Ov

CUSTOMIZATION BASICS: Framed Or Overlay Panels, Custom Handles and Accessory KitsOverlay panelsYou may also choose to install custom overlay panelsfro

1/4″ FRAMED PANEL DIMENSIONS7If you choose to install framed panels, they must be cutto the dimensions shown. The panels will slide into theframe on t

*84"2-9/16"24"*3" to 4"3/16"1-7/8"Design Guide8SIDE PANELSSide panels must be used whenever the sides of therefrige

Where a standard 2-prong wall outlet is encountered, itis your personal responsibility and obligation to have itreplaced with a properly grounded 3-pr