GE Monogram ZIPP360NHSS Manual de Instalação

Design Guide with InstallationInstructionsmonogram.com31-49074224D3560P002 12-14 GE36” Built-In French Door, Bottom-Freezer Refrigerators

STEP 2 INSTALL WATER LINE• A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120 p.s.i.•

11 STEP 2A WATER LINE INSTALLATION WITH A REVERSE OSMOSIS SYSTEMSkip this step when not using an RO SystemIf the water supply to the refrigerator is

12Installation Instructions STEP 4 ANIT-TIP PROCEDURE (CONT)• The anti-tip wall bracket has a series of holes. Select 2 holes that match with the

13 STEP 5 LEVEL REFRIGERATORAll models have 4-point leveling. The front is supported by leveling legs, the rear is supported by adjustable wheels. Bo

14Installation Instructions STEP 8 SECURE REFRIGERATOR TO CABINETRYWhenever possible, perform this step in addition to the Anti-Tip Procedures for

15Installation Instructions STEP 9 CONNECT WATER SUPPLY• Locate and bring tubing to the front of the cabinet.• Turn the water on to flush debris from

16Installation Instructions STEP 12 INSTALL TOEKICK• Locate the 2 supplied toekicks (shipped taped to the side of the refrigerator). Install the toe

17Notes

18Notes

19Notes

Safety Information2BEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT – Save these instructions for local inspector’s use.

NOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram® local service in your area, call

3AVERTISSEMENT Risque de basculement Ces réfrigérateurs présentent une partie supérieure lourde, en particulier avec une porte ouverte; ils doivent

Contents4Safety 2-3Planning GuideThe Installation Space 5Dimensions and Clearances 5130° Door Swing 690° Door Swing 7Side Panels 8Installation I

5Design Guide36" Frame to Frame Width*84" FromFloor toTop Frame35"Case Width*83 1/2" atRear25-3/4" Stainless Steel ModelsCase

1/4"1/2"3/4"1"1-1/4"1"3/4" OverlayPanel(Nominal Size)Stainless Steel1/4"1/2"3/4"2"1-1/4"1-

1/4"1/2"3/4"1"1-1/4"1/4"1/2"3/4"1"1-1/4"1-1/2"23-7/8"From Rear of Refrigerator3/4" Ov

*84"2-9/16"24"*3" to 4"3/16"1-7/8"Design Guide8SIDE PANELSSide panels must be used whenever the sides of the refrig

9TOOLS REQUIRED• Tinsnips to cut banding• Stepladder• Bucket• Level• Appliance Hand Truck• Tubing cutter• 7/16” open-end wrench• #2 Phillips screwdriv