GE Monogram ZUG30 Manual de Instalação descarregar pdf

Installation Instructions – ZUG30 Heater Kit/Cover

TO BE USED WITH HOUSEHOLD REFRIGERATORS

30" BUILT-IN

BOTTOM-FREEZER, 2 DRAWER

ALL REFERENCES TO ASSEMBLY ARE FROM THE FRONT OF THE UNITS

PARTS PROVIDED:

Installation Instructions (1)

Heater (1)

Transformer (1)

Plastic Cover (1)

Brackets (2)

Tools Required:

#2 Phillips Head Screw Driver

Step Ladder

Open Wrench Set

5 mm. Allen Wrench

IMPORTANT SAFETY NOTICE:

This kit is to be installed by a qualied service technician only. Any attempt to repair a major appliance may result in

personal injury and property damage. Neither the manufacturer nor the seller can be responsible for the interpretation

of this information or assume any liability in connection with its use.

197D9290P001 31-45446-1 05-12 GE

Unit 1 - Spacer Clips Installed

Unit 1

Unit 2

Unit 2 - Heater Installed

Spacer Clips (8)

Strain Relief (1)

Screw, 4.8 x 13 (4)

Bolt, M4 x 18 (2)

Nut, M4 (2)

Washer, star (4)

Bolt, M6 x 45 (3)

Nut, M6 (3)

Washer, at (6)

Wiring 'Y' Splitter (1)

NOTE: WHILE PERFORMING INSTALLATIONS

DESCRIBED IN THIS BOOK, SAFETY GLASSES OR

GOGGLES SHOULD BE WORN.

PPE Required:

Safety Glasses

Safety Gloves

BEFORE YOU BEGIN

Read these instructions

completely and carefully.

Disconnect power to the appliance before beginning installation.

Do not operate the refrigerator until the installation is complete.

WARNING

This refrigerator is top heavy and must be handled with care.

Failure to do so can result in the unit tipping over and re

sult in death or serious injury.

Do not cut lower banding on units.

Do not remove foam base pad from front of units.

STOP

1 2 3 4 5 6

Resumo do Conteúdo

Página 1 - Read these instructions

Installation Instructions – ZUG30 Heater Kit/CoverTO BE USED WITH HOUSEHOLD REFRIGERATORS 30" BUILT-IN BOTTOM-FREEZER, 2 DRAWER

Página 2 - Unit 1 Unit 2

1. This heater kit will only t two units, if the doors face each other when opened. Door swing of unit 1 must be switched from right hand swing to l

Página 3 - Heater lead wires

4. On Unit 2, use top and center holes to locate the foil heater. There is a hole in the foil heater. This lines up with the hole at the center of th

Página 4

46. Attach joining brackets to rear of reach unit, using screws provided with kit, add spacer between brackets. Join with bolt, washers and nut. Do n

Página 5

5 Fasten heater leads to open slot in vent cover, using the strain relief provided with the kit. Vent coverStrain reliefHeater leadsLocate the verti

Página 6 - GEAppliances.com

NOTE: PRODUCT IMPROVEMENT IS A CONTINUING ENDEAVOR AT GENERAL ELECTRIC. THEREFORE, MATERIALS, APPEARANCE AND SPECIFICATIONS ARE SUBJECT TO CHANGE WIT

Comentários a estes Manuais

Sem comentários

GE Monogram ZUG30 Manual de Instalação

Consulte online ou descarregue Manual de Instalação para não GE Monogram ZUG30. GE Monogram ZUG30 Installation Instructions Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com não GE Monogram ZUG30